Before servicing the vehicle, refer to the Precautions Section. Before servicing the vehicle, refer to the Precautions Section. Install or connect the following: Oil pan gasket Oil pan Oil pan bolts, finger-tight. Page 26 Back to Top Fig. Tighten the four bolts to 37 ft.
Disconnect all required electrical connections and cables, retaining clips and retaining brackets. Be sure to mark them for reassembly. Remove the converter to exhaust manifold nuts. Tighten the bolt to 106 inch lbs. Remove the engine wiring harness bracket nut and bracket.
Disconnect all required electrical connections and cables and retaining clips. Refer to the Camshaft Specifications chart. Right Side Page 118 Specific to: Chevrolet Silverado 1500 2008 1. Assemble the removal puller with its shoulder on the bearing to be removed. Tighten the sensor to 15 ft. To install: Page 27 Fig. All worn or damaged drive belts should be replaced immediately.
Sealant application to oil pan gasket-4. Continue the installation in the reverse order of the removal procedure. Remove the bolts and the timing chain tensioner. Disconnect the negative battery cable. Clean the cylinder head bolts and the engine block bolt holes. Remove the cylinder head bolts. Disconnect the sensor lead at the sensor.
Start the engine and check for leaks. Tighten exhaust valve rocker arm bolts 1, 2, 7, and 8 to 22 ft. Loosen the valve rocker arm cover bolts. Timing cover alignment tool installation-4. Skid plate and related components-type two Page 75 Fig.
Install the air cleaner assembly and connect the negative battery cable. Coolant temperature sensor tightening torque: 4. Align the oil pump screen mounting brackets with the correct crankshaft bearing cap studs. Remove the engine skid plate, if equipped. Check for leaks, correct as required.
Make this simple tool to check camshaft bearing oil hole alignment Page 12 Inspection 5. Tighten the bolt to 12 ft. Remove the engine front cover. Inspect the oil pump internal oil passages for restrictions. Tighten the converter to exhaust manifold retaining nuts to 37 ft.
Disconnect the negative battery cable. Before servicing the vehicle, refer to the Precautions Section. Pre-assemble the oil pan gasket to the pan. Skid plate and related components-type one Fig. Temporarily install the balance shaft drive gear so that the timing mark on the gear points straight up, then remove the drive gear, turn the balance shaft so the timing mark on the driven gear is facing straight down.