Thank you for the submitter. My bulb was stuck pretty good, I used a pair of water-pump pliers looks like a tyrannosaurus head to loosen it. I actually removed my battery on my Camry. I just did this today. The answer is in the owners manual.
I have an air conditioner. Squeeze the sides and pull this plug off. I couldn't even tell my headlights were on. The cover is held in place by plastic rivets. Bu t remove the neg bat cable then the wires from the alt then the bolts holding it on. Can confirm that one does not need to remove the fuse panel or battery, but the battery driver side has little room to work in. I like how nowadays, you have so many options to choose from but I hate how you have to search the internet for reviews on so many products just so you don't get an inferior product.
You then remove the rubber boot from the back of the headlight. When aiming adjustment is necessary,contact your Toyata dealer I have a 93 camry. You can xerox copies of what you need to know, if they won't let you 'check it out'. Step 1: Determine which type of bulb your car uses: Open the hood and look behind the headlamp. Here are the steps that I took. The mentioned air vent tube is fastened with a plug that looks like a button from above, it only needs to be pulled up at this spot and then can be folded to the left.
Feel free to use any replacement light bulb sizes that are listed on Modified Life but keep in mind that all information here is provided as is without any warranty of any kind. My bulb was stuck pretty good, I used a pair of water-pump pliers looks like a tyrannosaurus head to loosen it. Don't brake or damage it because you will have to put it back. Turn the bulb and remove it. Halogen bulbs … get extremely hot. Burn out tail lights are a common reason for a police officer to pull you over, so we recommend changing all of the tail lights on your Camry whenever one is burnt out.
Then continue to turn it clockwise until you feel it lock in place. There is a collar that you have to twist about a quarter turn to remove. If the belt came off before a diagram is made: From the left side of the engine as you stand in front of it, imagine 6 pulleys. Pry off the carpeting in the trunk just behind the assembly and you will see two plastic pieces that seem to… I just did this yesterday. Again, mine was pretty sticky, but it will wiggle out if the tabs are aligned with the slots.
The bulb is attached to this knob and will come out with it. Whatever is easier for you. Make sure your sedan has the power to keep lighting up the night by installing new Toyota Camry headlights from AutoZone. I've only read how to do this - not done it on my own yet, so I expect to learn and be frustrated in my own replacement efforts later today. You … will then see a spring clip secured by a 1 Phillips head screw.
. Rotate the bulb and base unit until it seats in place. This is easily done by hand. Turn off the car and headlights. Depress the plastic tab on the plastic connector and remove the bulb from the wiring. We have 945 reviews on our Low Beam Headlight Bulb products for the 2000 Toyota Camry from previous customers.
I added the pictures I had taken during my work. What you have to do is to open the hood of your Toyota and dependant upon which side of the car the bulb is being replaced look behind the headlight. Push the clip forward and then down into it's notch. Or you may just be struggling to keep it highway-approved. You could also maybe use a pair of needle-nosed pliers.